Murphys Laws: Klipstein's Laws Applied to General Engineering to Klipstein's Laws Applied to Prototyping and Production
(Murphy's Laws collected: 1583)
Klipstein's Laws Applied to General Engineering : Any wire cut to length will be too short.
Klipstein's Laws Applied to Prototyping and Production : Tolerances will accumulate unidirectionally toward maximum difficulty to assemble.
Klipstein's Laws Applied to Prototyping and Production : If a project requires n components, there will be n-1 units in stock.
Klipstein's Laws Applied to Prototyping and Production : A motor will rotate in the wrong direction.
Klipstein's Laws Applied to Prototyping and Production : A failsafe circuit will destroy others.
Klipstein's Laws Applied to Prototyping and Production : A transistor protected by a fast-acting fuse will protect the fuse by blowing first.
Klipstein's Laws Applied to Prototyping and Production : A failure will not appear until a unit has passed final inspection.
Klipstein's Laws Applied to Prototyping and Production : A purchased component or instrument will meet its specs long enough, and only long enough, to pass incoming inspection.
Klipstein's Laws Applied to Prototyping and Production : After the last of 16 mounting screws has been removed from an access cover, it will be discovered that the wrong access cover has been removed.
Klipstein's Laws Applied to Prototyping and Production : After an access cover has been secured by 16 hold-down screws, it will be discovered that the gasket has been omitted.
Suggest a Murphy's Law for this list. Contact : SanjeevDotNet at gmail dot com :
